Specifications

System Programming
IM166-107
Specialized Route Access (SRA) Configuration - continued
Insert Digits: You can program the
system, on a per line group basis, to insert
up to six digits before a dialed number. This
‘eature is useful if the dialed number must
match a specific format for the line group
oeing used.
Overflow Line Group: You can assign an
overflow line group that the system can
route calls over when no lines are free in
the line group assigned to the matching
entry; otherwise, the system will return
busy tone to the caller when this condition
exists.
NOTE: if you have arranged for the system
to insert digits on a particular line
group, consider arranging for the
system to insert digits in the overflow
line group as well. This consideratio
is necessary only if it is important for
the call to route through the same
common carrier as was the original
line group.
SRA Wait Time: Once a caller begins to
dial digits, he or she has a certain period of
time in which to dial each new digit. After
the caller has stopped dialing digits and the
end of the time-out period has occurred,
the system analyzes the dialed digits and
routes the call by following the table-driven
routing scheme. Use this procedure to
select the SRA wait time.
Assign or clear insert digits by performing the following steps,
1. Type I f 7 4 6 % and press RETURN,
2. From the main menu, type 1 and press RETURN
for system COS menu,
3. From the system COS menu, type 16 for specialized route
access menu and press RETURN,
4. Type 8 for assign insert digit menu and press RETURN,
5. Type l-4 for line group number and press RETURN,
6. Type SRA insert digits (maximum of six) and press RETURN,
7. Repeat steps 1-3 to assign insert digits for each line group,
8. To clear the insert digits if needed, type 9 and press RETURN,
then type l-4 for line group number and press RETURN
repeat as necessary,
9. To return to the main menu, press and hold CTRL and type C.
1. Type I * 7 4 6 +N and press RETURN,
2. From the main menu, type 1 and press RETURN for
system COS menu,
3. From the system COS menu, type 16 for specialized route
access menu and press RETURN,
4. From specialized route access menu, type 6 for overflow line
group and press RETURN,
5. Type 1 - 4 for line group l-4 or 0 for no line group
and press RETURN,
6. To return to the main menu, press and hold CTRL and type C.
Assign ARS wait time by performing the following steps,
1. Type I # 7 4 6 + and press RETURN,
2. From the main menu, type 1 and press RETURN
for system COS menu,
3. From the system COS menu, type 16 for specialized route
access menu and press RETURN,
4. Type 10 for assign ARS wait time menu and press RETURN,
5. Type 2,3, or 4 for 2,3, or 4 seconds and press RETURN,
6. To return to the main menu, press and hold CTRL and type C.
(TAB1 17~18) 4-70D