Specifications

IMl66-107 System Programming
Specialized Route Access (SRA) Configuration
0 To make a record of the programming configuration, mark the desired requirements in the records chart.
0 Use the sequence of steps listed below to program for the specialized route access (SRA) feature using your
VDT. You can on/y program the SRA feature from the VDT and not from station 10.
Enable The SRA Feature: The SRA 1. Type I + 7 4 6 +N and press RETURN,
feature allows the system to select a line
2. From the main menu, type 1 and press RETURN for
group based on the digits the user has system COS menu,
dialed. By doing this, it matches calls with 3. From the system COS menu, type 16 for specialized route
their best suited routes. The feature
access menu and press RETURN,
provides a table-driven routing scheme 4. From specialized route access menu, type 1 for enable/disable
where the numbers the users dial cause
choice menu and press RETURN,
the system to chose a line group after 5. Type 1 to enable or type 0 to disable feature and
comparing the dialed number with entries in
press RETURN,
an office code table, and area code table
6. To return to the main mehui, .press and hold CTRL and type C.
or, four special area code tables.
When you enable the SRA feature, you
must first clear all assigned prime line, idle
line preference and direct line appearance
to inhibit all direct line access-for the
system stations, and you must assign lines
to the line groups that you plan for the
system to use.
4-70A
(TAB1 17~15)