Specifications
IMl66-107 System Programming
Analog Terminal Interface Configuration
The Analog Terminal Interface device (ATI-D) is a multipurpose
m-oren&
accessory for’the digital telephone
system. It has dual circuits that allows external analog telephony equipment, such as an ExecuMail voice mail
system, an industry-standard model 2500 tone dial telephone, a model 500 rotary dial telephone, etc., to
interface with two digital station ports. Refer to Comdial publication lMl69-037,
Installation
instructions
For The
Analog Terminal
interface
(AT/-D)
for complete details for using the ATI-D to interface between the digital,
telephone system and external analog equipment.
0
To make a record of the programming configuration, mark the desired requirements in the analog terminal
interface records chart found at the end of Chapter 4.
0
To make the programming selections, dial the feature code and then dial the configuration code (or press the
programming button where appropriate).
NOTE: A lighted LED next to the programming button for the selection indicates the current
configumtion.
When a
sing/e
button
provides a toggle (on/off) action, the lighted LED indicates the active feature.
0
The first step in any programming sequence is to enter the base level. Once in this mode, you can dial the
feature code for any desired configuration. Enter the base level with the following procedure: press ITCM then
dial
+N
# 7 4 6
SC.
The last step is to press the
SPKR
button to end the programming procedure and return the
system to normal operation.
ATI Distinctive Ringing
1. Dial 53.
“STATION FEATURES”
Intercom calls that ring at equipment
2. Dial 33.
“DIST.
RINGXX
”
connected through an ATI-D have a
3. Press
Al
to toggle between enable and disable
different cadence than outside calls have.
(LED On = Enable)
Intercom ring cadence is: 1 sec. on, 0.5 -OR-
sec.
off,
1 sec. on, 3.5 sec. off. Outside call
4. Dial
1
to Enable.
l
IST. RING ON
’
ring cadence is: 2 sec. on, 4 sec. off. If
(Al LED on)
needed, you can disable this distinctive
Dial 2 to Disable.
PIST.
RING OFF
n
ringing feature to make the intercom ring
5. Dial
*
for
next
feature.
cadence the same as that for outside calls.
-OR-
Dial
+R
+#
for configuration mode.
To change setting, repeat procedure and make opposite selection.
ATI Thru Dialing
1. Dial 53.
“STATION FEATURES”
With this programming feature enabled, 2. Dial 07.
“ATI
THRU DIALING”
DTMF signalling tones that are generated 3. Select station ports (LED On = Selected)
by the external analog equipment pass
Station 10
-
57: Dial
10
-
57
or press
Cl 0
-
C57.
through the ATI-D, the common equipment,
4. Dial
+#
for next feature.
and any line connection into the switched
-OR-
network. The system automatically
Dial
+K
*
for configuration mode.
enables this feature when you connect the
ATI-D to the digital station port. Equipment
To change setting, repeat procedure and make different selection.
such as the Execumail voice mail system
and the 2500 tone dial telephone require
thru dialing; however, you should disable
this feature for equipment such as model
500 rotary-dial telephones.
4-47