Specifications

IM166-107
System Programming
Account Code (With Positive Forced Verification) Configuration - continued
Account Codes (Verified Entry)
1. Dial 75 “SMDA PROGRAMMING”.
Use this programming procedure to 2. Dial 08 ” VERIFICATION XXX’.
arrange for the system to either verify or
3. Press Al to toggle the feature on or off (LED On = Verified).
not verify the account codes that the user’s
-OR-
enter.
4. Dial 1 to enable verification. ’ VERIFICATION ON ‘:
Dial 2 to disable verification. ’ VERIFICATION OFF:
5. Dial +K 8 for configuration mode.
To change setting, repeat procedure and make opposite selection.
Account Code Length (For Verified Codes)
To specify the number of verifiable account code digits,
This feature defines the number of digits that the
1. Dial 75.
“SMDA PROGRAMMING
system will verify before it accepts the account
2. Dial 15.
“DIGITS VALID X u
code as valid. Verified aCCOUnt code length also
defines the number of valid account codes that
3. Dial number of digits 3 - 18 to be verified.
the system will store (as shown in the following
4. Dial G# t for configuration mode.
table). Be aware that when you change fhe
To change setting, repeat procedure and make different selection.
verified account code length, the system
empties the current list of valid account codes.
To specify the number of entered account code digits,
Digits Verified
Number of Codes 1. Dial 75.
“SMDA PROGRAMMING’
3
1000
2. Dial 09
“MAX ACCT CODE X ”
4
400
5,6
266
3. Dial number of digits (3 - 16) for account code length.
7,6 200
Entered digits must be at least equal to verifiable digits specified
9, 10
160
above but can be a maximum of 16.
11,12 133
4. Dial G# t for configuration mode.
13,14
114
To change setting, repeat procedure and make different selection.
15,16
100
Account Code Length (For Entered Codes)
This feature defines the number of account code
digits that a user must enter before the system
will accept the code. Account code length can
range from 3 to 16 digits; however, its length
must always be equal to or greater than the
current verified account code length.
Account Code List To create the list of usable account codes,
Use this programming feature to create the 1. Dial 75.
“SMDA PROGRAMMING”
list of account codes for use.
2. Dial 05. “SETACCT. CODE ”
3. Dial account code digits. Maximum number of digits must be
equal to number of account code digits specified in previous
programming step titled Account Code Length (Verfied).
4. To enter another account code, dial #, then dial its number.
5. Dial W for configuration mode.
To clear account codes from list,
1. Dial 75.
“SMDA PROGRAMMING”
2. Dial 06.
“CLEAR ACCT. CODE
3. Dial account code to be removed.
4. TO remove another account code, dial #, then dial its number.
5. Dial * t for configuration mode.
4-45