Specifications
System Programing
Station Configuration
D
To make a record of the programming configuration, mark the desired requirements in the station class of
service records chart found at the end of Chapter 4.
D
To make the programming selections, dial the feature code and then dial the configuration code (or press the
programming button where appropriate).
VOTE: A lighted LED next to the programming button for the selection indicates the current configuration.
When
a single button provides a foggle (on/off) action, the lighted LED indicates the active feature.
D
The first step in any programming sequence is to enter the base level. Once in this mode, you can dial the
feature code for any desired configuration. Enter the base level with the following procedure: press ITCM then
dial
+H#
7 4 6
+R.
The last step is to press the
SPKR
button to end the programming procedure and return the
system to normal operation.
Make station port selection by dialing a selection number on the keypad or pressing the console button per the
following reference chart.
STATION PORTS KEYPAD BUTTONS
CONSOLE BUT-TONS
10-57
10-57
ClO-c57
Station Configuration
-
Miscellaneous
Features
kcess
Denied
lou
can deny access to certain lines at
:ertain stations. When you do this, a
station user cannot select a denied line.
1. Dial 54.
“STAILINE CONFIG.
*
2. Dial 5.
“ACCESS DENY”
3. Select line ports (LED On = Access Denied):
Line port 1-14 = Dial
01
-
14
or press
Al
-
Al4
Line port
15,16
= Dial
15,16
or press
Bl
, B2.
Line port 17-24 = Dial 17
-
24 or press
HOLD
then press
Al
-
A8
4. Dial # when all line ports are selected.
5. Select station ports (LED On = Feature Assigned):
-
Station 10
-
57: Dial
10
-
57
or press
Cl0
-
C57.
6. Dial
+R
when all station ports are selected.
-OR-
Dial
+R
+#
for next station/line feature.
-OR-
Dial
+R
+#
++
for configuration mode.
To change setting, repeat procedure and make opposite selection.
4-22