Installation Instructions

Americana Building Products .
9
Sierra Patio Cover Installation Guide
STEP 1
Mark a level line on the surface where the shade structure is to be mounted. Recommended 5-1/2”
minimum above an out-swinging door or window.
It is recommended that the front height of the shade structure be lower than the mounting height 1/2”
per foot of projection. It is NOT recommended to install the shade structure completely flat. DO NOT
direct drainage toward the back of the shade structure.
To properly determine the mounting height, add post (C) length, plus header height, plus the required
drop.
EXAMPLES:
12’-0” Projection = 6” Drop
10’-0” Projection = 5” Drop
8’-0” Projection = 4” Drop
STEP 2
Using a 3/16” bit, drill holes every 12” - 16” through
the mounting surface, depending on wall stud
spacing.
NOTE: Shade structure must be attached to a solid
structural support. DO NOT attach to sheathing,
siding, flashing, or any other non-structural surface.
1
2