Installation Instructions

Americana Building Products .

Sierra Patio Cover Installation Guide

SIDE VIEW

STEP 13

Position the lock of the next roof panel (V) over the

lock of the previous panel. Snap the locks together

by hooking the locks and rolling the panel down.

Slide the panel into mounting channel (B) until the

front end is flush with the previous panel. Repeat

steps 11-12 on page 23 to attach roof panel (V) to

mounting channel (B) and the header.

NOTE: It is very important to maintain the 8”

dimension between the center of the locks of each

roof panel (V). Standard units come pre-drilled for

easy installation. Line up the holes in the panels

with the holes in mounting channel (B) and header

(D).

Repeat for all remaining roof panels (V).

When you reach the end of the cover, remove

the last panel before installing the second-to-

last panel. Then re-install the end panel.

Once all roof panels (V) are installed, tighten all

screws, bolts, and nuts at attachment points.

STEP 14

Install a fascia clip (J) on each roof panel (V)

through the pre-punched square hole at the front of

the panel.

Continue on page 25