Installation Instructions

Americana Building Products .

Sierra Patio Cover Installation Guide

STEP 11 - 8” FLAT STYLE ROOF PANELS

Attach one roof panel (V) at each end of the cover

before attaching other panels to ensure the cover

stays square.

Attach the formed end of roof panel (V) to mounting

channel (B) using (2) #8 x 1/2” bolts (DD), #8 hex

nuts (EE), and 1/2” washers (FF) through the

pre-drilled holes. Insert roof panel flashing plug (W)

between the roof panel (V) and mounting channel

(B).

STEP 12

Attach roof panel (V) to C Channel header (D) using

(2) #14 x 3/4” SMS screws (CC) through the pre-

drilled holes. DO NOT completely tighten screws at

this time. This will allow you to adjust the roof

panels during installation to ensure the cover stays

square.

NOTE: If using optional 3” box beam header (S) or

3” x 8” header (T), attach roof panel (V) using #14 x

3/4” Tek screws (JJ).

The first and last panels should overhang the ends

of the header by approximately 3-1/2”. Accordingly,

the first and last screws must be offset slightly to

reach the header.

FRONT VIEW