Installation Instructions

Americana Building Products .

Sierra Patio Cover Installation Guide

STEP 13

Position the lock of the next roof panel (G) over the

lock of the previous panel. Snap the locks together

by tapping the top with a rubber mallet along the

length of the panel. If necessary, have assistance

hold a spare 2x4 board under the locks. Slide the

panel into mounting channel (B) until the front end

is flush with the previous panel. Repeat steps 11-12

on page 21 to attach roof panel (G) to mounting

channel (B) and the header.

NOTE: It is very important to maintain the 10”

dimension between the center of the locks of each

roof panel (G). Standard units come pre-drilled for

easy installation. Line up the holes in the panels

with the holes in mounting channel (B) and

header (D).

Repeat for all remaining roof panels (G).

When you reach the end of the cover, remove

the last panel before installing the second-to-last

panel. Then re-install the end panel.

Once all roof panels (G) are installed, tighten all

screws, bolts, and nuts at attachment points.

STEP 14

Install a fascia clip (J) on each roof panel (G)

through the pre-punched square hole at the front of

the panel.

Continue on page 25

FRONT VIEW

SIDE VIEW