Installation Instructions

Americana Building Products .

Sierra Patio Cover Installation Guide

STEP 11 - 10” ‘V’ STYLE ROOF PANELS

Attach one roof panel (G) at each end of the cover

before attaching other panels to ensure the cover

stays square.

Attach the formed end of roof panel (G) to mounting

channel (B) using #8 x 1/2” bolt (DD), #8 hex nut

(EE), and 1/2” washer (FF) through the pre-drilled

holes. Insert roof panel flashing plug (L) between

the roof panel (G) and mounting channel (B).

STEP 12

Attach roof panel (G) to C Channel header (D) using

(2) #14 x 3/4” SMS screws (CC) through the pre-

drilled holes. DO NOT completely tighten screws at

this time. This will allow you to adjust the roof

panels during installation to ensure the cover stays

square. This will also allow you to insert optional

bird plugs (X), if ordered, see page 28.

NOTE: If using optional 3” box beam header (S) or

3” x 8” header (T), attach roof panel (G) using #14 x

3/4” Tek screws (JJ).

The first and last panels should overhang the ends

of the header by approximately 3-1/2”.

FRONT VIEW