User`s manual

BIOS Setup

Main Advanced Boot Server Security Clk/Voltage Defaults Exit

Set Supervisor Password Item Help

Set User Password Menu Level}

Password Check [Setup] Change/Set/Disable

Password

higf: Move Enter: Select +/-/PU/PD: Value F10: Save ESC: Exit F1: General Help

F5: Previous Values F7: Optimized Defaults F8: Q-Flash

Security

When you select this function, the following message will appear at the center of the screen to assist

you in creating a password.

Type the password, up to eight characters, and press <Enter>. You will be asked to confirm the

entered password. Type the password again and press <Enter>. You may also press <Esc> to abort the

selection and not enter a password.

To disable password, just press <Enter> when you are prompted to enter password. A message

“PASSWORD DISABLED” will appear to confirm the password being disabled. Once the password is

disabled, the system will boot and you can enter Setup freely.

The BIOS Setup program allows you to specify two separate passwords:

SUPERVISOR PASSWORD and a USER PASSWORD. When disabled, anyone may access

all BIOS Setup program function. When enabled, the Supervisor password is required for entering the

BIOS Setup program and having full configuration fields, the User password is required to access only

basic items.

If you select “System” at “Password Check” in Advance BIOS Features Menu, you will be

prompted for the password every time the system is rebooted or any time you try to enter Setup Menu.

If you select “Setup” at “Password Check” in Advance BIOS Features Menu, you will be prompted

only when you try to enter Setup.

Figure 5: Security