Installation guide

4-2 Install Hard disk

DVR-800 & 1600 could support 2 Hard Disks. If you install one hard disk only,

please set it as Secondary IDE “Master”. If you install the 2nd hard disk, please set it

as Secondary IDE “Slave”.

First, configure the jumper of hard disk as Master (refer to manual of hard disk),

then link hard disk with 40-pins parallel cable to the Secondary IDE slot (the white

one on the GA-8IEX).

Please pay attention to the direction of the 40-pins parallel cable. Some cheap

cable without “foolproof” may cause mistake. Normally, there is a red line marked on

the 1

pin of the cable, which should be connected to 1

pin of hard disk and IDE slot.