Installation guide

3. Install the Flash Module & Hard Disk

4-1 Install the Flash Module

In general, there are two IDE slots, one is Primary (the red one on GA-8IEX),

and the other is Secondary. Please plug the System Module into Primary IDE slot and

set it as “Master”, then connect the D-type power line to power supply as the figure

below.

If you would like to install the internal CD/RW burner also (DVR-800 & 1600

supports the internal CD/RW and USB external CD/RW both), please use the special

cable as the figure below which is included in the shipping box to connect the system

module (set as Primary IDE Master) and the internal CD/RW (set as Primary IDE

Slave).

Connect to internal CD/RW burner

(Set as Primary IDE “Slave”)

Plug into the

primary IDE slot

Connect to system module

(Set as Primary IDE “Master”)