Installation guide

7. Boot and Test

7-1 Connect Cameras

Please put cameras at fix positions, then finish adjusting and calibrating.

Connect cameras to Capture Cards with 5C2V coaxial cables. Capture Cards use BNC

female connector. If your cameras only have F connector, you need to buy the

“BNC to F” adapters.

7-2 Boot and Test

When first booting, system will enter the “Disk Management” option. Please

refer to the Section 4 of the Hyper Vision 16 user manual for the related procedures

for the hard disk management. After finishing the disk management, the system will

reboot and show the main monitoring screen as follows.

After rebooting, if DVR does not appear this GUI (Graphical User Interface),

and show out the text: “Hyper Vision Login: “, it means your display card doesn’t

match, please check the Chapter 1 for the right display card again.