Installation guide

6-2.for Gigabyte GA-8SG667
Please select [Load Optimize Defaults] in the main menu to load optimum
setting, then please refer to the setting listed in the next.
[Standard CMOS features]
IDE Primary Master [PQI IDE Secured Disk]
IDE Primary Slave [None]
IDE Secondary Master [your hard disk]
IDE Secondary Slave [None]
Drive A [1.44M, 3.5“]
Drive B [None]
Floppy 3 Mode Support [Disabled]
Halt on [All, But Keyboard]
[Advanced BIOS Features]
First Boot Device [HDD-0]
Second Boot Device [Disabled]
Third Boot Device [Disabled]
Boot Up Floppy Seek [Disabled]
Password Check [Setup]
Init Display First [AGP]
[Integrated Peripherals]
IDE1 Conductor Cable [Auto]
IDE2 Conductor Cable [Auto]
On Chip Primary PCI IDE [Enabled]
On Chip Secondary PCI IDE [Enabled]
AC97 Audio [Disabled]
USB Controller [Enabled]
USB Legacy Support
[Disabled]
Onboard Serial Port 1 [3F8/IRQ4](Enable for modem)
Onboard Serial Port 2 [2F8/IRQ3](Enable for PTZ)
Onboard Parallel Port [Disabled]
Game Port Address [Disabled]
12