Operator`s manual

2-6
2.2.3. VIDEO OUTPUT
This version of the TICO is equipped with the added feature of being
able to connect directly to a remote video monitor or recorder via an
integrated video output port.
1. Connect the video cable to the sights video output port.
2. Connect the video cable to the appropriate recording device.
Operation:
1. Turn on the system
by pressing the POWER
button.
2. Let screen image settle
before transferring video
to the monitor.
3. Press the “Up” and
“Down” arrow buttons
simultaneously, as show
in the photo above. The
Video image will now be able to be viewed through the TICO eye-
piece and the monitor at the
same time.
The user, while looking
through the TICO eyepiece,
will be able to tell if video is
being displayed on the mon-
itor, because the VID icon
will be visible in the bottom
left corner of the eyepiece.
4. To turn off the Remote
Video Output, repeat step 3.
NOTE
The image seen in the TICO sight will be smaller than its
actual resolution, due to the video processing differing
from that of a monitor.
FIGURE 2.7. OPERATION SWITCHBOARD
VIDEO
OUTPUT PORT
FIGURE 2.6. TICO WITH VIDEO CABLE