Operator`s manual



E. DUAL BRIDGE

The Dual Bridge (A) is designed to connect two units into a bin-

ocular configuration.

Dual Bridge also allows the binocular configuration to be attached

to the headmount or helmet mount.

To mount the units with Dual Bridge per form the following :

1. Align the unit and the Dual Bridge.

2. Push the clamps (B) on the front of Bridge.



the alignment groove (C) on the Bridge. Push until the unit locks

into the Bridge.

4. Repeat for second unit.

To detach the unit push the clamps on the front of Dual Bridge

and slide the unit for wards.



a pair of dual tube binocular.

Figure 3-5

Mounting of the Dual Bridge

H. MOUNTING IR- 450 TO THE ATN NVM-14

IR- 450 may be mounted on t he m o no cular through the Picat inny

adapter.

1. Mount Picatinny adapter(A) onto one of the rails on the

monocular. Tighten two fixing screws(B) of the adapter.

2. Loosen the IR-450 fixing screw (C).