Installation Guide

Install OVERFLOW GASKET (1) onto OVER FLOW FLANGE (2)
using two strips of double-face tape (included).
Apply a bead of silicone sealant to upper edge of 0VERFLOW
GASKET (1).
Push OVER FLOW TUBE ASSEMBLY (3) up flush against
underside of ledge.
Install and align mounting holes in RETAINING PLATE (4) with
holes in OVER FLOW FLANGE (2). Insert MOUNTING SCREWS (5)
through RETAINING PLATE (4) into OVER FLOW FLANGE (2).
Note: RETAINING PLATE (4) must be installed as shown with
open side facing out.
Tighten SLIP JOINT NUTS (6, 6a) to make water tight connections.
Install OVERFLOW ESCUTCHEON (1) onto RETAINING PLATE (2).
Use MOUNTING SCREWS (3) to secure OVERFLOW
ESCUTCHEON (1). Fig. 1.
Peel protective tape from the AMERICAN STANDARD LOGO (4).
Align LOGO (4) and press into place. Fig. 2.
Thread TOE TAPPER DRAIN PLUG (5) into DRAIN PLUG (6).
4
3
3
1
1
4
5
6
2
1
4
5
2
3
1
4
2
3
6
6a
4
SECURE OVERFLOW ASSEMBLY TO TUB
(OVER-THE-RIM DRAIN)
3a
SECURE OVERFLOW ASSEMBLY TO TUB
(STANDARD DRAIN)
INSTALL OVERFLOW ESCUTCHEON
(OVER-THE-RIM DRAIN)
FIG.1
FIG.2
NOTE: TUB IS SHOWN CUT AWAY
FOR CLARITY OF INSTALLATION.
NOTE: TUB IS SHOWN CUT AWAY
FOR CLARITY OF INSTALLATION.
SEALANT
753995-100 Rev. D
U
P
F
R
O
N
T
Align the holes in the RETAINING PLATE (1) with those in the OVERFLOW
FLANGE (2). Install SCREWS (3), tighten snugly (do not over tighten). The
overflow gasket (behind tub wall) will begin to seal as the RETAINING
PLATE (1) becomes tighter. The overflow gasket can be rotated for
desired fit.
Align the ESCUTCHEON (4) with the RETAINING PLATE (1) and
push onto RETAINING PLATE (1) until the ESCUTCHEON (4)
snaps into place.
Peel protective tape from the AMERICAN STANDARD LOGO (5).
Align LOGO (5) and press into place.
When you are satisfied with the overall fit of the drain,
go back and tighten all joints to make a water tight seal.
5