Installation Guide

PIPE
CAP
1
PIPE PLUG
TUB FILLER
NIPPLE
1-1/2" REF.
Remove pipe cap and plug from shower and tub
rough piping.
Slip TUB SPOUT (1) onto tub nipple and tighten with
4mm Hex Wrench.
Apply Teflon Tape to both ends of SHOWER ARM (2).
Install SHOWER ARM (2) with FLANGE (3) into shower pipe and tighten.
Thread SHOWER HEAD (4) onto ARM (2) and tighten.
Push SHOWER ARM FLANGE (3) to wall and tighten SET SCREW (5)
with 5/64” hex wrench.
2
INSTALL TUB SPOUT, SHOWER HEAD,
SHOWER ARM WITH FLANGE
CAUTION: Protect finish on SHOWER
HEAD and TUB SPOUT when installing.
4MM HEX
WRENCH
SHR.
ELBOW
INSTALL VALVE TRIM
1
5
4
6
(4) ALIGNMENT
HOLES FOR
DIAL PLATE
1
2
3
When finished tiling the wall, remove PLASTER GUARD (1)
and turn off water supply.
Push CAP (2) over VALVE CARTRIDGE (3).
Mount ESCUTCHEON (4) to valve body with SCREWS (5).
Push DIAL PLATE (6) over CAP (2) and into the four alignment
holes in ESCUTCHEON (4).
M965429
C
H
C
5
2
3
HEX
WRENCH
TEFLON TAPE