Manualshelf

Installation Guide

ManualsBrandsAmerican Standard ManualsPlumbingPortsmouth 1-Handle Diverter Valve Trim Kit in Oil Rubbed Bronze with Cross Handle (Valve Not Included)
123
M965032 REV.1.5 (4/15)
OPERATING THE VALVE
1
Place ESCUTCHEON (1) onto ESCUTCHEON HOLDER (2).
Align ESCUTCHEON (1). Thread ESCUTCHEON HOLDER (2) onto DIRVERTER VALVE (3).
Tighten until ESCUTCHEON (1) is snug against fiished wall.
TRIM INSTALLATION
1
2
3
3
Turn water supply on and test installed fitting.
Rotate handle to all diverter positions to check operation of valve.
Check for leaks.
2
HANDLE INSTALLATION
2
1
3
4
5
6
Rotate the slot on KNOB MOUNT (1) about 15˚ to the left and install
onto VALVE STEM (2). Make sure to push KNOB MOUNT (1) until it
is properly installed against valve.
Thread HANDLE SCREW (3) into VALVE STEM (2) and tighten.
Align the two Ribs inside the HANDLE (4) with the slot on the
KNOB MOUNT (1). Push HANDLE (4) onto KNOB MOUNT (1).
Tighten SET SCREW (5) in handle with
HEX WRENCH (6) supplied.
15˚
15˚
RIBS
VIEW “A”
SLOT
SLOT
HANDLE (4)
HANDLE RIBS
VIEW “A”
KNOB MOUNT (1)