Installation Instructions

4
- 3 -
M965821 (8/17)
• Loosen SET SCREW (1) with HEX WRENCH (2). Pull off HANDLE (3). Remove HANDLE SCREW (4) and
HANDLE ADAPTER (5). Pull off HANDLE BASE (5).
• Check that arrow marking B points to the 3 o’clock position. If not, push the RED CLAMP on
the SECURING RING to the right, pull off KNOB MOUNT (6) and reinstall KNOB MOUNT (6) with arrow “B” 3
o’clock position. See Figure 1.
SET HOT LIMIT STOP
• The maximum mixed water temperature is set at 109˚F at the factory. This setting can be changed if desired.
• Remove the TEMPERATURE LIMIT STOP (4) (H shaped Red Plastic part). Re-install it at the desired notch as
indicated in the diagram to limit the maximum mixed water temperature to 104˚F or 112˚F.
• For 100˚F adjustment, turn the water supply on. Turn KNOB MOUNT (6) until the spout temperature is 100˚F.
Check that arrow “A” on the KNOB MOUNT (6) still points 3 o’clock position after adjusting the thermostat to
100˚F. If not, pull out the RED LOCKING DEVICE. Remove KNOB MOUNT (6) by pulling it towards you while
standing directly in front of the valve.
• Reinstall the KNOB MOUNT (6) with arrow “A” 3 o’clock position.
• Re-install RED LOCKING DEVICE (5).
• See step 2 for HANDLE (3) installation.
TEMPERATURE ADJUSTMENT
6
1
6
4
ARROW
"A"
BLACK
CLAMP
ARROW
"B"
RED LOCKING
DEVICE
TEMPERATURE
LIMIT STOP
ARROWS AT 3 O'CLOCK
POSITION
Figure 1
KNOB MOUNT
112
109
104
2
3
5