Installation Instructions

- 2 -

• Install HANDLE ADAPTER (1) onto HANDLE BASE (2)

and tighten with SCREW (3).

• Align HANDLE (4) and push onto HANDLE ADAPTER (1).

• Tighten SET SCREW (5) in handle with HEX WRENCH (6)

SUPPLIED.

• Install HANDLE ADAPTER (7) onto KNOB MOUNT (8).

• Push VOLUME CONTROL KNOB (9) onto HANDLE

ADAPTER (7). Use HEX WRENCH (6) supplied and

tighten SET SCREW (10) to secure VOLUME CONTROL

KNOB (9).

Should the hot and cold water supply pipes have been transposed

making adjustment impossible, proceed as follows:

• Shut off water supply.

• Remove handle and rim. (Reverse steps 1 and 2)

• Remove check stops and re-install them transposed.

• Important Note: RED CHECK STOP is now on the right of the

mixer body and the BLUE CHECK STOP is now on the left.

• Turn the water supply back on and perform the temperature

adjustment in step 4.

• Assemble HANDLES and TRIM.

HANDLE INSTALLATION

TRANSPOSED SUPPLY PIPING OR BACK TO BACK INSTALLATION

• Remove PLASTER GUARD (1) if attached.

• Push CAPS (2 & 2a) as shown onto CONTROL

VALVES (3).

• Push ESCUTCHEON HOLDER (4) with lightly greased

O-RING SEALS (5) over CAPS (2, 2a). Attach

with the two SCREWS (6) provided.

• Place ESCUTCHEON (7) over ESCUTCHEON

HOLDER (4) and push evenly for a snap t.

TRIM INSTALLATION

M965821 (8/17)

CHECK STOP

(RED TO BLUE)

CHECK STOP

(BLUE TO RED)

TOP