Installation Guide

M965613 REV. 1.8 (11/16)
7
Fig. 2
Fig. 2a
Fig. 3
Fig. 3a
BLACK & WHITE
POWER
CONNECTIONS
16
12
CONNECTOR NOT
USED IN THIS
INSTALLATION
12
10
11b
15
4" CONTROL BOX
OR EQUIVALENT BY
OTHERS
14
AC POWER
SUPPLY
2
1
4
10
AC POWER
SUPPLY
9
8
AC VERSIONS (HARDWIRE / PLUG-IN);
Fig. 2 and Fig. 3
B
CAUTION
Before opening CONTROL BOX
disconnect AC power supply.
1. Remove CONTROL BOX COVER (1) from CONTROL BOX
(2). Fig. 2.
2. Feed the EXTENSION CABLE (3) from the faucet through
GROMMET (4). Then connect the SOLENOID CABLE (5) to
EXTENSION CABLE (3). Install CONNECTOR LOCKING
DEVICE (6). Fig. 2a.
3. Insert POWER CORD (9) through OUTER GROMMET (10)
as shown. Connect it to the SINGLE AC ADAPTER (11). Fig. 2a.
4. Connect POWER CORD (9) to EXTENSION CABLE (8)
from faucet sensor. Replace CONTROL BOX COVER (1).
Tighten cover screws firmly.
Prior to making power connection, make sure
detection zone is not obstructed. Sensor is
self adjusting. Keep detection zone clear for 15
seconds after power is connected.
5. Plug AC POWER SUPPLY into wall outlet. Fig. 2a.
FOR HARDWIRE HOOKUP ONLY; Fig. 3
6. Insert 10 ft. EXTENTION (11a) from HARD WIRE POWER
SUPPLY (12) into CONTROL BOX through OUTER GROMMET
(10) and side GROMMET (4). Connect 10' Extension (11a) to
SINGLE AC ADAPTER (13). Fig. 3.
7. Insert EXTENSION CABLE (8) from faucet through
GROMMET (4a) and connect to SINGLE AC ADAPTER (13).
Replace CONTROL BOX COVER (1). Tighten cover screws
firmly. Fig. 3.
Contractor to supply ELECTRICAL BOX (14) and power to
POWER SUPPLY (12). Fig. 3a.
8. Connect White and Black connections to POWER SUPPLY
CONNECTIONS (15). Fig. 3a.
Prior to making power connection, make sure
detection zone is not obstructed. Sensor is
self adjusting. Keep detection zone clear for 15
seconds after power is connected.
9. Connect the 10 ft. EXTENSION (11b) to the POWER SUPPLY
CABLE (16). Mount POWER SUPPLY (12) into ELECTRICAL
BOX (14).
FOR PLUG-IN HOOKUP ONLY; Fig. 2
11a
13
7
3
8
4
4a
!
!
CAUTION: Use only American Standard supplied
transformers and cable sets. Using non-AS
supplied cables, or cutting, splicing or modifying
any components will void the warranty.
5
3
11
6