Installation Guide

M965613 REV. 1.8 (11/16)
6
1. Remove CONTROL BOX COVER (1) from
CONTROL BOX (2). Fig. 1.
2. Feed the EXTENSION CABLE (3) from the Faucet
through SIDE GROMMET (4). Fig. 1a.
3. Connect SOLENOID CABLE (5) to EXTENSION
CABLE (3) from the Faucet. Fig. 1a.
4. Insert BATTERY (6) into BATTERY HOLDER (7),
make sure the shape of the BATTERY (6) follows the
shape of the BATTERY HOLDER (7) and terminal
end is inserted first. Fig. 1b.
5. Connect the BATTERY CONNECTOR (7a) from the
Standard or PWRX Battery to EXTENSION CABLE
(8) as shown. Fig. 1c. Place Standard Battery or
PWRX into Housing. Fig. 1d.
6. Replace CONTROL BOX COVER (1). Tighten cover
screws firmly.
PWRX & STANDARD
BATTERY; Fig. 1
A
ELECTRICAL INSTALLATION
Fig. 1a
Fig. 1b
Fig. 1
Fig. 1c
5
5
Fig. 1d
3
2
1
6
7
INSTALL BATTERY
STANDARD
BATTERY
STANDARD
BATTERY
PWRX
CR-P2
7a
7a
8
4
PWRX
CAUTION: Use only American Standard supplied
transformers and cable sets. Using non-AS
supplied cables, or cutting, splicing or modifying
any components will void the warranty.
Product Page
Plug-in AC Powe Kit
(PK00.PAC)
7
Hard-Wired AC Prower Kit
(PK00.HAC)
7
MULTI-AC Power Kit
(PK00.MAC)
8