Installation Guide

710443-100 Rev. 2 8/20
11
In Step 10, we will cover attaching the hardware to the Sliding Wall Post.
This will require parts 20, 21 and 26.
10
In Step 11, we will cover applying silicone to seal your shower doors.
11
10a. Three hole locations are predrilled into the Post [20] and can be
used to mark drill locations in the Sliding Wall Post [21] from the
inside of shower. Remove Post and drill marked locations using a
1/8" (3.2mm) drill bit.
11a. Apply silicone at all inside and outside locations as shown. Allow 24 hours
for silicone to dry before use.
10b. Place Post [20] back onto Sliding Wall Post [21} and use 3 supplied
M4x8 screws, placing white plastic cups through each screw to hold
Screw Cover Caps [26]. Screw and secure Post into place onto the
Sliding Wall Post.
10c. Cover each screw head with a Screw Cover Cap [26] to finish.
10a
10b
10c
[25]
[26]
Screw M4x8
Ø3.2mm