Installation Guide

710443-100 Rev. 2 8/20
10
In Step 8, we will cover adjusting the Sliding Door Panel [32].
8
In Step 9, we will cover installing the Aluminum Seal [29].
9
8a. Once all assembly is completed, it may be necessary to adjust the Sliding
Door Panel [32] for proper operation. This can be achieved by adjusting
Rollers [8] attached to the Sliding Door Panel [32] by loosening the metal nut
on the Roller.
9a. Position the Aluminum Seal [29] at the entrance floor/Sliding Door Panel [32]
side of the shower in-line with the Fixed Panel [31]. Apply a bead of adhesive
in the groove or underside of the Aluminum Seal and place back at shower
entrance keeping the sloping side of the seal pointing inside the shower area.
9b. Two connector [30] ends are supplied to cover any gaps at the 2 ends of the
Aluminum Seal which can be placed on the left and right side pointing inside
the shower area.
8b. Use a 10mm socket to slightly loosen the metal nut on the Roller and an 18mm
open end wrench to turn the plastic retainer, providing an oblong effect when
adjusting or turning, causing the door to move up or down at that location.
Adjustments can be done to both Rollers to obtain proper door sliding operation
and fit.
9a
9b
9b
[25]
[26]
Screw M4x8
Ø3.2mm
[8] [8]
MIN
MAX
8a
8b
[8]
[8]