Installation Guide

710443-100 Rev. 2 8/20
8
[2]
6a
6b
6d
[18]
6e
3/8"
10mm
[18]
6f
3/8"
10mm
[32]
[8]
6c
3/8"
10mm
11/16"
18mm
[8]
[32]
[2]
[18]
6
In Step 6, we will cover assembling the rollers and sliding glass panel door.
This will require parts 2, 8, 18 and 32.
6c.
Remove 10mm metal nut and 18mm plastic retainer from Roller [8] and carefully place threaded end
into hole of outside facing Sliding Door Panel [32] keeping clear plastic washer between roller and
glass panel. From inside shower side of panel, place 18mm plastic retainer into threads of Roller and
into hole of glass Panel. Turn to tighten.
6a. Separate door handles [2] by removing brass connector with threaded stem from handles. Place the
round bushing and clear square gasket over the threaded stem and onto the Sliding Door Panel [32]
keeping clear washers between the glass panel. Then place the other handle over brass connector.
6b. Tighten allen screws to secure Door Handle in place.
6d. Attach metal nut and tighten using 10mm socket and 18mm open end wrench for plastic retainer.
Repeat steps 6c and 6d on opposite side.
6e. Slide Bottom Door Gasket [18] onto bottom of sliding Door Panel [32] keeping the wider ap to the
inside of shower area.
6f. If necessary, cut or trim the Door Gasket material about 3/8" (10mm) off the edge of the sliding
Door Panel.