Installation Guide

710443-100 Rev. 2 8/20
6
[31]
[22]
3b
[7]
3a
4d
4c
In Step 3, we will cover the assembly and installation of the fixed door panel.
This will require parts 6, 7, 17, 21, 22, 23, 24, 27, 28 and 31.
3
In Step 4, we will cover the installation of the sliding door post.
This will require parts 21, 23 and 24.
4
3a. Ensure clear Shim [7] is in groove on Bottom Guide [6] for Fixed Panel side.
NOTE: Place a minimum of 2 clear channel shims in bottom of U channel.
3c. Check that Fixed Panel is fully and securely in place and panel is at far end (close to
flush) on groove of Bottom Guide.
4a. To install Sliding Wall Post [21] place on opposite side of shower entrance wall
and mark approximately 1-5/8" (42mm) from threshold edge of shower base.
Remove wall post and set aside.
4b. Ensure Sliding Wall Post is plumb, then mark all 4 screw hole locations.
4c. Drill pilot hole at each marked location using a 1/4" (6mm) drill bit (if using
Wall Anchors [24]).
4d. Insert Wall Anchors [24], place Wall Post into position and screw using
M4x35 [23].
3b. Carefully place Fixed Panel [31] fully into U Channel [28] and Fixed Wall Post [22].
NOTE: Identify the fixed door panel by the 2 holes at the top of the glass panel. Refer
to Assembly drawing [31].
NOTE: Product is heavy and REQUIRES TWO PEOPLE for installation.
!
[28]
[22]
[21]
[31]
3d. Once panel is leveled and in place, insert Water Deflector [17] on inside shower
between Fixed Panel [31] and Fixed Wall Post [22].
3c
[17]
3d
[21]
4b
[21]
4a
1-5/8"
42mm
Clear
channel
shims
Clear
channel
shims