Installation Guide

9
M965652 Rev. 2.4 (6/21)
Fig. 4
CR-P2
6
3
2
STANDARD
BATTERY
PWRX
4
1
5
Fig. 5
1
2
D
INSTALL / REPLACE THE BATTERY
or PWRX; Fig. 4
1. Remove COVER from CONTROL BOX (1).
2. Disconnect BATTERY HOLDER (3) from CABLE (5).
3. Remove old BATTERY from Battery Holder (3). Install new
BATTERY (2) making sure the terminal side is inserted rst
and shape of the battery follows the shape of the BATTERY
HOLDER (3).
4. To replace PWRX BATTERY PACK (4), unplug and replace
with new Power Pack.
5. Reconnect BATTERY HOLDER (3) to CABLE (5).
6. Reinstall CONTROL BOXT COVER. Tighten cover
screws rmly.
E
CLEAN AND REMOVE THE AERATOR; Fig. 5
1. AERATOR (1) may accumulate dirt causing distorted and
reduced water ow. Remove AERATOR (1) by using the
AERATOR KEY (2) and rinse to clear any debris.