Operating instructions

12 Pub. No. 18-HE56D1-9
Installer's Guide
23. Cover the exposed screw tips on the outside of the
cabinet. Locate the six 1-1/4" foam disc pads from the
hardware packet and apply them over the screw tips on
the outside of the cabinet. This will protect the homeowner
from any contact with these screw tips. See Figure 37.
Figure 37
24. Demonstrate to homeowner Maintenance (Section H) and
Door Operation (Section C).
NOTE: The door has a safety switch to ensure power is
interrupted when the door is removed. This switch is open
when the door is removed from the cabinet. When the
door is properly installed, an actuator tab located in the
cabinet will close the switch, allowing power to the
electronics.
NOTE: Make sure to bend the locking tab that will hold
the Field Charger in place. Do NOT bend the locking tab
that would prevent removal of Collection Cells. See Figure
36.
22. Complete Electrical Connection (Section E) and Air
Cleaner Operation and Set Up (Section F).
Figure 36
Field Charger
Locking Tab
Actuator Tab for
Interlock Switch
Place circular foam
disc pads over screw tips
protruding from case.
Repeat on other side
Third screw and foam
sticker - Optional
NOTE: Failure to cover the exposed screw tips on the
outside of the cabinet could result in scrapes and cuts.