Operating instructions

10 Pub. No. 18-HE56D1-9
Installer's Guide
17. Install the PRE-FILTER and COLLECTION CELLS.
18. Each COLLECTION CELL must be oriented with the
handles toward the front.
Figure 29
Figure 28
14. Clean the back of the existing cabinet to insure that it is
dust free before adhering the new insulation spacer.
15. Install the proper insulation spacer determined in Figure
27, by peeling the paper off and pushing the spacer in
place. See Figures 28 and 29. Center the insulator on
the back wall against the cabinet flange closest to the
indoor unit. Press the insulator film against the back
wall to secure.
16. Place Field Charger into cabinet. Re-check with gauge
to ensure Field Charger falls into the range indicated
with 1 dot. (Review Figure 27).
13. Remove Field Charger from the cabinet.
Figure 30
Figure 31
19. Remove Model number/Serial number label from the kit
and place on the bracket as shown in Figures 30 and 31.
Note: Pictured enclosure is not installed on a furnace.
CENTER