Installation Guide

- 2 -
755908-100 Rev. 1 06/20
ILLUSTRATION 6
Dry t the rst piece of cut trim to the window, ensuring there are no gaps around the corners.
NOTE: Approximately 2-1/4" of the trim’s front surface (that faces the shower area) will protrude
beyond the window to account for the required overlap.
4
Proceed to a second piece of trim measuring, cutting, sanding and dry tting for a proper t over the window area.
When mating one piece of trim with another, ensure the cut ends overlap under the decorative squares. Proceed
to cut all remaining pieces of trim, ensuring there are no gaps.
Press trim into place ensuring there are no gaps. Clean off any excessive adhesive.
5
Starting with the rst piece of trim cut in step 3, apply
DAP 3.0 Advanced Hybrid or DAP Kwik Seal Ultra
Sealant on all inside areas.
See ILLUSTRATION 5
Proceed to the other 3 cut pieces of trim in the same mannor, one piece at a time, keeping
the cut end under the decorative square until all 4 pieces are installed with no gaps.
Once all 4 pieces of trim are installed, apply DAP
Kwik Seal Ultra Sealant or DAP 3.0 Advanced Hybrid
to all open joints or gaps to ensure a water tight seal.
See ILLUSTRATION 6
ILLUSTRATION 5
BACK VIEW
Refer to Tub or Shower Wall installation instructions (755905-100) for cleaning instructions.
6
7
8
9