User`s manual

SummaCut cutter User’s Manual
Detailed Operation 4-14
4.3.27 Cal. Media
Media calibration ensures that the sensor is able to recognize the markers. This is explained
in section 3.2.2
4.3.28 Cal. OPOS
This test calibrates the physical distance between the OPOS sensor and the knife tip. It is
explained in section 3.2.1
4.3.29 OPOS Parameters
The OPOS settings sub-menu is used to change the different OPOS parameters with the
control panel. It is explained in section 3.3.5
Extra parameters are:
Sheet mode
Is explained in section 3.4.3
OPOS Panelling
With this option, the markers can be read in panels. The OPOS sensor will read markers
according to panel size, instead of loading them all be.
OPOS Panels can be set to OFF or ON. When set to ON, then the sensor will load only 2
markers in X-direction when loading OPOS. Other markers will be read when unrolling
media.
The panel size will be set automatically to the distance between two markers in the X
direction.
OPOS Origin
These settings are explained in section 3.4.1
4.3.30 OPOS Sensor
This submenu is to test the reflection value of OPOS. Press for readout.