User`s manual

SummaCut cutter User’s Manual
Detailed Operation 4-12
4.3.21 ROM Revision
Press the button to view information about the cutter’s ROM revision. This information is
often helpful to technicians when diagnosing problems over the telephone.
4.3.22 Recut offset:
The Recut offset submenu is used to set or modify the distances between the jobs when
making multiple recuts.
Press , then use or to change the Baudrate. Press to confirm or to
cancel. The default value is 40mm.
4.3.23 Media Sensor
The media sensor detects whether media is loaded and also detect the end of the media.
The sensor prevents damage to the cutting strip and knife tip. The sensor can be activated
or deactivated with this menu.
The cutter will stop, during the loading procedure or while it is cutting, if the rear sensor
detects the end of the media.
Press , then use or to activate (ON) or deactivate (OFF). Press to confirm
or to cancel.
The default setting for the media sensor is ON.
4.3.24 Sensor Setup
The media sensor setup option is a useful routine for checking whether the media sensor is
functioning properly and whether the switching levels of the sensor is correctly set.
1. Press .
2. Put a piece of media half on the sensor and under the two outer pinch rollers and press.
.
3. There are five levels of sensitivity to choose from, use or to change the
sensitivity level
After choosing a sensitivity level, the S value will change on the LCD. When the sensor is covered
then the length of the arrow will reach (completely) at the right side of the LCD. When the senor is
uncovered, then the length of the arrow will be (almost) 0.
Sensor uncovered
Sensor covered
FIG 4-4
4-4 SENSOR SETUP