User`s manual

SummaCut cutter User’s Manual
Detailed Operation 4-3
4.2.8 Replot
The RECUT instruction recuts the last file sent to the cutter (provided that it fitted into the
buffer). Press the key to execute the instruction.
4.2.9 Load
This menu can be used when loading sheet material. During the loading, the maximum
material length can be set.
4.2.10 Extended Load
This parameter is explained in section 1
4.2.11 OPOS Barcode
Click on this to start the barcode workflow (see section Error! Reference source not
found.).
4.2.12 Media alignment
Align load is a special loading procedure to register markers so that pre-printed jobs can be
contour-cut. The parameter is explained in section 3.3.6
4.2.13 System Setup
Press to access the rest of the parameters and internal tests.