User`s manual

SummaCut cutter User’s Manual
Contour Cutting 3-17
3.4.2 Cutting multiple copies of a graphic on the same roll
If the same graphic design has been printed on a roll with equal distance between the
different graphics, then this feature can be used.
This way of automating is very software dependable. Usually are necessary parameters need
to be set in the software itself. In rare cases, the distance between jobs needs to be set in
the cutter itself. The only possible way to do this is to use Summa Cutter Control
3.4.3 Cutting the same graphic on multiple media sheets
If the same graphic design has been printed on a multiple sheets, then this feature can be
used.
NOTE: The sheets should be more or less the same size, and the graphics on them
should be oriented and positioned the same way.
First, load the media and check that the parameters of the OPOS markers are set correctly.
Cutting the same graphic on multiple media sheets:
1. Power on the cutter.
2. Press .
‘Velocity’ will appear on the LCD.
3. Press .
‘System Setup’ will appear on the LCD.
4. Press .
‘Confidence’ will appear on the LCD.
5. Use or to scroll through the menu until ‘OPOS Settings’ is reached, press
.
‘X Distance’ will appear on the LCD.
6. Press or until ‘Sheet Mode’ appears on the LCD.
‘Sheet mode’ is visible on screen.
7. Press to confirm.
The value of the chosen parameter will appear on the LCD.