User`s manual

SummaCut cutter User’s Manual
Contour Cutting 3-16
OPOS origin is set to ‘Current Position’
Upon receiving an OPOS job from the computer, the cutter will immediately start searching
for the OPOS XY line by moving the media slowly forward. Once it has found it, it will follow
this line to the right until it finds the first mark and then start searching for the first mark.
Therefore, the user will have to set the origin under the OPOS XY line immediately after that
the media has been loaded.
This setting has been created for jobs are left aligned and differ a lot in size on the roll. The
origin/tool can then be set to the left of the media under the OPOS XY line so that the origin
mark can be found, even it is far away from the right side of the media.
OPOS origin is set to ‘Centre of media’
Upon receiving an OPOS job from the computer, the cutter first set the OPOS sensor in the
middle of the media. Then it will start searching for the OPOS XY line by moving the media
slowly forward. Once it has found the XY line, it will follow it to the right until it finds the first
mark and then start searching for the first mark.
This setting has been created for jobs on a roll where the width of each job is at least half
the width of the media (this is usually the case; otherwise there is a lot of wasted media).
This method is slightly slower than the previous method.