User`s manual

SummaCut cutter User’s Manual
Contour Cutting 3-15
3.4.1 OPOS origin
The parameter OPOS origin is created to automate the start of the OPOS procedure. This
parameter has 4 settings. The usage of this parameter is dependent of the chosen OPOS
mode.
This parameter can be found in the system sub menu OPOS parameters (see section 4.3.28)
If the OPOS is OPOS barcode or OPOS Sheet, then this parameter has no effect.
The useful combinations are in the table below.
OPOS X
OPOS XY
Mark
‘Indicate Mark’
‘Indicate Mark’
XY-correction line
-
‘Indicate Line’
Current Position
‘Current Position’
‘Current Position’
Center of Media
-
‘Center of media’
3.4.1.1 In combination with OPOS X mode
OPOS Origin is set to ‘Mark’.
This is the default setting. Upon receiving an OPOS job from the computer, the cutter will
prompt the user to set the tool above the first mark and press Apply. The cutter will then
start searching for the OPOS mark around that position.
OPOS Origin is set to ‘Current position’.
Upon receiving an OPOS job from the computer, the cutter will immediately start looking
for the mark when it gets an OPOS job from the computer without waiting for the user to
move the tool. Therefore, the user will have to set the tool above the first mark while
loading the material.
If OPOS origin is set to either ‘XY-correction line’ or ‘Center of media’, then the cutter will
react as if the parameter was set to ‘indicate mark’
3.4.1.2 In combination with OPOS XY mode
OPOS Origin is set to ‘Mark’.
This is the default setting. Upon receiving an OPOS job from the computer, the cutter will
prompt the user to set the tool above the first mark and press Apply. The cutter will then
start searching for the OPOS mark around that position.
OPOS origin is set to ‘Indicate line’
Upon receiving an OPOS job from the computer, the cutter will prompt the user to set the
tool under the OPOS XY line and press Apply. The cutter will then start searching for the
OPOS XY line by moving the media slowly forward. Once it has found it, it will follow this
line to the right until it finds the first mark and then start searching for the first mark.