User`s manual

Table of contents I

Table of Contents

1 Setup ............................................................................................................... 1-1

1.1 Unpacking the Cutter .......................................................................................... 1-1

1.1.1 Removing the packaging from the cutter ...................................................................... 1-1

1.1.2 Setting up the machine with a stand ............................................................................... 1-2

1.1.3 Setting up the machine without a stand ........................................................................ 1-4

1.2 SummaCut Cutter Components ......................................................................... 1-5

1.2.1 The Cutter as viewed from the front ................................................................................ 1-5

1.2.2 The Cutter as viewed from the back ................................................................................ 1-7

1.3 Connecting the Cutter to the Mains ................................................................... 1-9

1.3.1 Grounding (“Earthing”) ......................................................................................................... 1-9

1.3.2 Operating voltage ................................................................................................................... 1-9

1.3.3 Powering-on the cutter ..................................................................................................... 1-10

1.4 Connecting the Cutter to a Computer ............................................................. 1-11

1.4.1 USB connection .................................................................................................................... 1-11

1.4.1.1 Connecting the SummaCut cutter to a PC using a USB cable .................... 1-11

1.4.1.2 Connecting the SummaCut cutter to a Mac using a USB cable ................. 1-12

1.4.2 RS-232 Connection .............................................................................................................. 1-13

1.5 Loading Media ................................................................................................... 1-14

1.5.1 Pinch roller positioning...................................................................................................... 1-14

1.5.2 Loading media ...................................................................................................................... 1-15

1.5.3 Media load procedure ........................................................................................................ 1-18

1.6 Tool Installation ................................................................................................ 1-20

1.6.1 Knife installation ................................................................................................................... 1-20

1.6.2 Pen installation ..................................................................................................................... 1-24