Service manual

ManualsBrandsAmerican Standard ManualsBurnerD100-270

DESCRIPTION

DRAFTHOOD

DIP TUBE

FLUE BAFFLE

HAND HOLE TANK COVER

DRAIN VALVE

HAND HOLE COVER JACKET

HAND HOLE COVER O-RING

(not pictured)

HAND HOLE COVER GASKET

(not pictured)

HEAT SHIELD

MAIN BURNER TUBE(S) QUANTITY AND LENGHT VARY DEPENDING ON MODEL

BURNER RODS, SETS OF 2 PER BURNER (SOME MODELS)

BURNER TRAY

PILOT BURNER ASSEMBLY

PILOT SUPPLY TUBE

MAIN BURNER MANIFOLD

GAS VALVE

(Emergency shut-off device)

MAIN BURNER ORIFICE

CONTROL BOX COVER

(Spark Ignition models)

TRANSFORMER

(Spark Ignition models)

IGNITION CONTROL

(Spark Ignition models)

TERMINAL BLOCK

(Spark Ignition models)

CONTROL BOX

(Spark Ignition models)

THERMOSTAT

(Emergency shut-off device)

CAPILLARY TUBE COVER

DAMPER HARNESS

(Flue Damper models only)

FLUE DAMPER

(Flue Damper models only)

ANODE ROD

(Not pictured)

TANK LEG THERMAL BREAK (Required on all combustible floor installations)

MANUAL SHUT-OFF VALVE IF APPLICABLE

(Emergency shut-off device)

Rod Clips (4per burner) - Some Models

Rod Spring (2 per burner) - Some Models

NOTES

150158 Rev. 2 August - 2010

REPLACEMENT PARTS LIST (SEE PAGE 18)

PARTS REPLACEMENT MUST BE PERFORMED BY A QUALIFIED INSTALLER,

SERVICE AGENCY OR GAS SUPPLIER

The following parts may be ordered through your plumber, a local plumbing supply company, or direct from the

factory. Parts will be shipped at prevailing prices and will be billed accordingly. Refer to warranty for company

address.

IMPORTANT: When ordering replacement parts, provide model number, serial number, type of gas, item

number (from the following list), part description, voltage and wattage (when applicable).

It is imperative that replacement of main burner orifices, pilot burner and gas valve be ordered for the gas type.

Natural gas valves will be marked with a 4.0” w.c. manifold pressure setting (see rating plate). L.P. Gas valves

will be marked with a 10.0” w.c. setting.

PART NO.