Service manual

150158 Rev. 2 August - 2010
14
THIS OPERATING INSTRUCTIONS ARE ONLY FOR D80-512 AS MODEL
FOR YOUR SAFETY READ BEFORE LIGHTING
WARNING: If you do not follow these instructions exactly, a fire or explosion
may result causing property damage, personal injury or loss of life
A. This appliance is equipped with an ignition device
which automatically lights the pilot. Do not try to
light the pilot by hand.
B. BEFORE OPERATING smell all around the
appliance area for gas. Be sure to smell next to
the floor because some gas is heavier than air
and will settle on the floor.
• Do not try to light any appliance.
• Do not touch any electric switch; do not use
any phone in your building.
• Immediately call your gas supplier from a
neighborʼs phone. Follow the gas supplierʼs
instructions.
• If you cannot reach your gas supplier, call the
fire department.
C. Use only your hand to push in or turn the gas
control knob. Never use tools. If the knob will not
push in or turn by hand, donʼt try to repair it, call
a qualified service technician. Force or
attempted repair may result in a fire or explosion.
D. Do not use this appliance if any part has been
under water. Immediately call a qualified service
technician to inspect the appliance and to replace
any part of the control system and any gas
control which has been under water.
OPERATING INSTRUCTIONS
1. STOP! Read the safety warnings above on this
label.
2. Set the thermostat to lowest setting.
3. Turn off all electrical power to the appliance.
4. This appliance is equipped with an ignition
device which automatically lights the pilot. Do not
try to light the pilot by hand.
5. Turn ON/OFF switch on the water heater to the
“ON” position. See ON/OFF switch position
figure.
6. Wait five (5) minutes to clear out any gas. If you
then smell gas, STOP!Follow “B” in the safety
information above on this label. If you don t smell
gas, go to next step.
7. Set thermostat to desired setting.
8. If ignition of the pilot and main burner is not
established n approximately one minute, turn the
electric supply to the heater “OFF” and then back
“ON”. This will reset the ignition cycle.
9. Repeat steps until ignition of the pilot and main
burner is established.
10. If you appliance will not operate, follow the
instructions “To turn Off gas to appliance” and
call your service technician or gas supplier.
11. Check all pipe connections in the gas line and at
the gas valve for gas leaks. Use a soap and
water solution for this operation. NEVER USE
AN OPEN FLAME FOR THIS PURPOSE.
12. Damper must be in open position when
appliance main burner is operating.
SWITCH POSITION
Note: Gas valve control #7010 does not have a manual “ON” “OFF” knob
TO TURN OFF GAS TO APPLIANCE
1. Set the thermostat to lowest setting.
2. Turn off all electrical power to the appliance if
service is to be performed.
3. Turn the gas valve knob clockwise to
”OFF” position.