Installation Guide

1
2
INSTALLATION AND FRAMING INSTRUCTIONS
INSTALLATION OF DRAIN ASSEMBLY
1a. Ensure that the oor and stud walls are square and plumb on a level oor as shown in Figure A.
Provide a 7" x 7" (178 x 178 mm) opening in the oor for the drain and refer to the product rough-in
on the specication page for actual drain location.
NOTE: Maximum weight support of 300lbs without mortar. Mortar is required during installation for user
weights exceeding 300lbs.
2a. All of the shower bases require purchasing a round drain for use with a standard 2” (51 mm) plastic
schedule 40 waste pipe. Figure B shows the typical drain assembly. Before installing drain into the
shower base, remove strainer. (Ref. Figure B) This will be installed after shower base is in its nal position.
Cut the waste pipe height so that the drain body will t snug in the shower base. Apply silicone sealant
between the drain body and shower base.
NOTE: Drain not included and must be purchased separately.
The alcove opening dimensions should be at least 1/8" (3mm) larger than dimensions shown on
spec page for the model being installed.
For the best t, the opening measurements should be veried against the actual
shower base received.
FIGURE A
90°
90°
2" (51 mm)
PVC Waste Pipe
Opening 6" x 6"
(152 x152 mm)
C/L
(See Product Rough-In on specification page for Drain Location)
DRAIN ASSEMBLY
Strainer
Drain
Body
Shower
Base
Silicone
Sealant
Rubber
Gasket
Fiber
Gasket
Locking
Nut
Rubber
Caulking
Gasket
FIGURE B