Product specifications

9
9
If necessary, cut the internal jumper wire (JP1).
24RC
24RH
W1
24RC
24RH
W1
OR
24RC
24RH
W1
Do NOT cut JP1 jumper
Cut JP1 jumper
If only one wire is connected
to either 24RC or 24RH
as shown
If wires are connected to
both 24RC and 24RH
as shown
Cutting the JP1 jumper
The jumper is located on back of the thermostat face as shown in the illustration to
the right. Cut the jumper using small diagonal cutters being careful not to damage
the board.
11
Turn power to heating and cooling system back on.
The thermostat display should turn on and begin displaying information. If the thermostat display does not come on, go back through the
installation steps and look for problems.
10
Attach the thermostat face to the wall plate.
a. Carefully align the face plate to the wall plate while aligning pins into wire terminals.
b. Once thermostat face is properly aligned, apply pressure at top and bottom of thermostat face
until it is secure.
24RC
G
Y1
Y2
RS2
RS2
24C
24RH
W1
W2/O
RS1
RS2
Shld
HC
Shld
H1
CUT JUMPER TO
SPLIT RC/RH
HC
SHLD
RS1
24C
24RH
W1
W2/O
RS1
H1
SHLD
RS2
24RC
G
Y1
Y2
RS2
JP1
JP1 JP1
CUT JUMPER TO
SPLIT RC/RH
SPLIT RC/RH
CUT JUMPER TO