Operation Manual

27
1. Press until COOL is displayed.
2. Enter your cooling program by following the
same procedure you followed for entering your
heating program.
CHECK YOUR PROGRAMMING
Follow these steps to check your thermostat
programming one final time before beginning
thermostat operation.
1. Press
SYSTEM
SWITCH
until HEAT is displayed.
2. Press and hold
VIEW
PRGM
to view the heating
period times and temperatures in sequence
for weekday, then weekend MOR, DAY,
EVE, and NHT program periods.
3. Press
RUN
PRGM
.
CAUTION
!
If outside temperature is below 50°F, we
recommend that you remove the thermo-
stat from the wall before proceeding with
the following steps to program cooling
temperatures. A fresh 9V alkaline bat-
tery must be installed to perform off-wall
programming. Programming away from
the wall should prevent accidental com-
pressor operation. BE SURE SYSTEM
SWITCH IS SET TO OFF POSITION BE-
FORE REATTACHING THE THERMO-
STAT TO THE SUBBASE!
SYSTEM
SWITCH
Enter Cooling Program