Installation Sheet

M965031 REV.1.2
OPERATING THE VALVE
1
TRIM INSTALLATION
1
3
6
2
4
2
HANDLE INSTALLATION
3
Place ESCUTCHEON HOLDER (3) over VALVE COVER (1). Line up holes in ESCUTCHEON HOLDER (3) with THREADED TABS (4) on VALVE.
Install MOUNTING SCREWS (5) through ESCUTCHEON HOLDER (3) and into THREADED TABS (4). Tighten SCREWS (5) securely.
Place ESCUTCHEON (6) over ESCUTCHEON HOLDER (3) and push evenly for a snap fit.
Push VALVE COVER (1) over VALVE CARTRIDGE (2) until it is seated against the stop.
5
Turn HANDLE into OFF position.
Turn on water supplies, and check all connections for leaks.
Operate HANDLE to flush water lines thoroughly.
Turn handle OFF.
2
Install HANDLE ADAPTER (1) onto VALVE STEM (2).
Install HANDLE SCREW (3) and tighten.
Align LEVER HANDLE (4) and push onto HANDLE ADAPTER (1).
Tighten SET SCREW (5) with HEX WRENCH (6)
supplied with trim kit.
1
3
4
5
6
OFF