l Sink Basin Installation Sheet

3. Above Counter OR 4. Drop-in
3
7301354-100
B
C
2-F
2-G
Connect trap to drain assembly hand tight to check
alignment. It may be necessary to cut off part of the
tailpiece (area “B”) or part of the horizontal leg of the
trap (area “C”). Secure joints for watertight assembly.
Connect supply line to faucet (finger tight) and
carefully bend tubes to engage with the supply
shut-off valves. Tighten connections at faucet
and shut-off valves for secure seal.
Shut-Off Valves
Countertop Installation:
• Place the sink temporarily into the template
• Check for alignment and clearance
• Mark the sink and countertop in several
places as a guide for the installation location.
Countertop Installation:
Using the template provided, locate the position of
the sink on the countertop. Provide proper clearance
under the countertop for the faucet supply lines, drain
assembly and the structural parts of the cabinet.
NOTE: If replacing an existing sink be certain to shut
off water supply before removing old sink.
3-A
4-A
Mount the faucet and drain assembly (not included)
on the sink following the manufacturer’s instructions.
Be certain to apply a bead of sealing putty on the
underside of the drain (Part “A”) in order to ensure a
watertight seal between the sink and drain. Remove
excess putty after installing drain on sink.
A
Drill a clearance hole inside the perimeter line
of the template for countertop installation.
Cut opening around the perimeter of the template.
Perimeter
of
template
Perimeter of
template
After checking fit and alignment, turn sink
upside down and apply a generous portion
of silicone adhesive around the under side
of the rim near the edge. Place sink in
position. Wipe off excess adhesive.
3-D
4-D
3-E
4-E
3-B
4-B
3-C
4-C