l Sink Basin Installation Sheet

ManualsBrandsAmerican Standard ManualsBathroom Remodel & Bathroom FixturesBoulevard Vitreous China Rectangular Pedestal Bathroom Sink with Overflow

7301354-100

2. Wall-hung on furniture

1-E

1-F

1-G

1-H

1-I

Install lavatory anchor

screws leaving 1-7/8"

threaded end exposed

as illustrated.

1-7/8"

ANCHOR SCREW

INSTALLATION

Use lag bolts to secure

lavatory as illustrated.

LAG BOLT INSTALLATION

Anchor

Screw

Washer

Lavatory

Nut

Lag

Bolt

Washer

Lavatory

Steel

Hanger

IMPORTANT: Final assembly of nut and washer or lag bolt method

shown for reference only.

Shut-Off

Valves

Rear

View

Pedestal

Screws

Return the fitted lavatory to the installed

position. Connect trap to drain assembly

hand tight to check alignment. It may be

necessary to cut off part of the tailpiece

(area "B") or part of the horizontal leg of

the trap

(area "C").

Following manufacturer's instructions,

install faucet and drain assembly (not

included). Be certain to apply a bead of

sealing putty

on the

underside of

the drain (area

"A") in order to

ensure a

watertight seal

between the

lavatory and

drain. Remove

excess putty

after installing

drain on

lavatory.

Secure lavatory to wall as

shown in 1E. Install washers

and hand tighten nuts or lag

bolts. Level and square the

unit. Connect hot and cold

supply lines to the shut-off

valves. Tighten trap joints for

watertight assembly.

Install pedestal screws.

Securely tighten lavatory

anchor nuts or lag bolts.

Note: Space constraints may

dictate method of fastening

pedestal to floor.

2-C

Vanity Installation:

• Place the sink temporarily on the vanity to

check for alignment and clearance

Mounting on Furniture:

Assemble vanity as per instructions.

2-A

Mount the faucet and drain assembly (not included) on

the sink following the manufacturer’s instructions. Be

certain to apply a bead of sealing putty on the

underside of the drain (Part “A”) in order to ensure a

watertight seal between the sink and drain. Remove

excess putty after installing drain on sink.

2-B

2-D

After checking fit and alignment, turn sink upside down

and apply a generous portion of silicone adhesive

around the under side of the rim near the edge. Place

sink in position. Wipe off excess adhesive.

2-E

Use the mounting holes on the rear of the lavatory

to secure the sink to the wall.