Installation & Assembly

- 2 -
2
M965991 (10/18)
MAKE WATER SUPPLY CONNECTIONS
LOOP SUPPLIES
IF REQUIRED
28"
1
2
COLD
COLD
HOT
HOT
Figure A.
• Turn off hot and cold water supplies before beginning.
• Connect FLEXIBLE SUPPLIES (1, 2) directly to wall supplies.
Connection on tting supplies are 3/8" compression.
Connect left supply to Hot and right supply to the Cold
wall supply. Use adjustable wrench to tighten connections.
Do not over tighten.
• Faucet supplies are 28" long from faucet base.
Note: If additional supply length is required,
installer must purchase additional parts separately.
Important: If SUPPLY HOSES (1, 2) are
too long, loop as illustrated to avoid kinking.
Figure A.
4
PUTTY
2
3
1
3
DRAIN INSTALLATION
• Install DRAIN (1) by dropping it from the top of the sink.
• From under side of SINK install GASKET (2) and
MOUNTING NUT (3).
Note: Plumber’s putty or caulk is recommended.
• Thread TAIL PIECE NUT (4) clockwise onto
DRAIN BODY (2).
• Check DRAIN FLANGE in SINK to ensure that
FOAM GASKET (3) is fully compressed and
not visible.
• Operate DRAIN (1) to verify that it opens and closes.