Installation & Assembly

- 4 -
4B
UNDER COUNTERTOP INSTALLATION
Under countertop mount cutout opening is determined by cabinet opening and should be 3/8" (9.5 mm) smaller than the
inner sides of sink and from back of sink apron. Carefully cut out the countertop opening, opening must be adequately
nished and sealed to prevent damage from water absorption.
Note: Check dimensions on first page as a reference and measure the sink being installed.
7302028-101
4A
FLUSH MOUNT INSTALLATION
Using carpenters square carefully measure and mark the location of the cutout opening in the countertop. Flush mount
cutout opening is determined from the actual sink size. The cutout opening should equal the maximum dimensions of the
sink to ensure a minimum gap between the sink and the countertop opening.
Note: Check dimensions on first page as a reference and measure the sink being installed.
ACTUAL SINK
DIMENSIONS
COUNTERTOP
CUTOUT DIMENSIONS
ACTUAL SINK DIMENSIONS
COUNTERTOP CUTOUT DIMENSIONS
ACTUAL SINK
DIMENSIONS
COUNTERTOP
CUTOUT DIMENSION
3/8"
(9.5 mm)
1"
(25 mm)
1" (25 mm)1" (25 mm)
3/8"
(9.5 mm)
COUNTERTOP
CUTOUT
DIMENSION
CABINET OPENING DIMENSION
• SOLID SINK WALLS
• CENTER DRAIN HOLE