Instruction Manual

7
123
879
456
1. After turning off power
supply, unbolt two nuts
and remove end plate.
2. Using a flathead
screwdriver or needle nose
pliers, remove clip from strain
relief portion of the cord.
3. Using wire cutters, cut black
(or brown) wire and white (or
blue) wire near the connectors.
4. Pull cord strain relief out
of endbell. Cut green ground
wire near the cord strain
relief.
5. Insert metal strain relief
connector (not included) into
the endbell hole and tighten
the nut securely.
6. Strip the green, black, and
white insulation from last ½”
of each wire.
7. Insert the power supply
cable, coming from the
wall junction box, through
the strain relief connector.
Tighten connector.
8. Connect disposal wire
leads (black and blue) to
corresponding wire leads
of the power supply cable.
Green always connects to
green.
9. Setting the wires into
the endbell, replace the
end plate and tighten the
two bolts.
PERMANENT WIRE INSTALLATION INSTRUCTIONS-ILLUSTRATED